elastic modulus

…maximum possible number of independent elastic moduli in the most general anisotropic solid were settled by the British mathematician George Green in 1837. Green pointed out that the existence of an elastic strain energy required that of the 36 elastic constants relating the 6 stress components to the 6 strains,…

…fender dent), and (2) its elastic modulus, defined as its ability to resist elastic or springy deflection like a drum head. By alloying, aluminum can be made to have a yield strength equal to a moderately strong steel and therefore to exhibit similar resistance to denting in an automobile panel.…

E is called Young’s modulus, and it has dimensions of [force]/[length]² and is measured in units such as the pascal (1 Pa = 1 N/m²), dyne/cm², or pounds per square inch (psi); ν, which equals the ratio of lateral strain to axial strain, is dimensionless and is called the…

…to strain is called the elastic modulus. If the load is increased further, however, a point called the yield stress will be reached and exceeded. Strain will now increase faster than stress, and, when the sample is unloaded, a residual plastic strain (or elongation) will remain. The elastic strain at…

…direction of propagation, only two elastic constants are required to specify acoustic properties of icosahedral quasicrystals. In contrast, cubic crystals require three elastic constants, and lower-symmetry crystals require up to 21 constants.

…percent by volume, raise the elastic modulus of the rubber by a factor of two to three. They also confer remarkable toughness, especially resistance to abrasion, on otherwise weak materials such as SBR. If greater amounts are added, the modulus will be increased still further, but the strength will then…

…of the ratio of the elastic modulus of the medium (that is, the ability of the medium to be compressed by an external force) to its density:

…required that of the 36 elastic constants relating the 6 stress components to the 6 strains, at most 21 could be independent. The Scottish physicist Lord Kelvin put this consideration on sounder ground in 1855 as part of his development of macroscopic thermodynamics, showing that a strain energy function must…